Logo

P04C8 Engine Code Repair

Meaning of P04C8 engine trouble code is a kind of powertrain trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

P04C8 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for P04C8 code is occuring now you should check P04C8 repair processes.
Now don't ask yourself; What should you do with P04C8 code ?
The solution is here :

P04C8 Possible Solution:

P04C8 Engine

Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.

P04C8 Code Meaning :

P
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine

0
Intake Valve Control Solenoid Circuit Low

4
Throttle/Pedal Position Sensor/Switch A Circuit Intermittent

c

8
Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical

Regarding the P04C8 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

P04C8 OBD-II Diagnostic Powertrain (P) Trouble Code Description

P04C8 engine trouble code is about Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical.

Main reason For P04C8 Code

The reason of P04C8 OBD-II Engine Trouble Code is Throttle/Pedal Position Sensor/Switch A Circuit Intermittent.

P04C8 DTC reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.